Getting it fired up for the first time
Well starting this was not as easy as I had first thought it to be. Replacing parts and putting them back to spec I imagined should do it but no it needs more than that.
The first few hours of kicking it around resulted in nothing but frustration.
The first few hours of kicking it around resulted in nothing but frustration.
Checked the fuel flowing in the fuel filter
Checked the spark plug, tip remove the plug leave it plugged to the cable and hold the metal portion against the engine and kick the kickstart if u see a nice blue spark your sparky is fine.
Still, no smoke and the engine just would not start. Then I found the following tips to start a 2 stroke engine.
- Choke on
- Tilt the bike so you can get enough gas into the carb
- Five small soft kicks to draw the gas into the carby.
- The ignition and a hard kick
And boom I had a brief amount of joy where the engine revved really high before dieing.
Now I had cleaned the tank, cleaned the air filter and rebuilt the carb with a new kit. That should do it, shouldn't it?
So after several similar attempts, I had to go back to the drawing board. So for anyone experiencing the engine rev really high and then bogging down, you have an air leak
So after several similar attempts, I had to go back to the drawing board. So for anyone experiencing the engine rev really high and then bogging down, you have an air leak
Comments
Post a Comment